Modified Novice Rules
This class has Spec Gearing, Battery and Tire requirements
Racers With two heat races with a average top 15 lap time of 7.6 seconds or less will be required to advance from Novice Class.
Chassis: 1 Modified
RTR Traxxas Modified, Traxxas Part # 104354-74
All chassis parts are to remain stock with factory wheelbase 13.1in
Body:
the only legal body is traxxas #10411 a factor body and interior, custom paint allowed car numbers must be displayed on both sides of the car and roof.
Nose tie-down permitted
Air cleaner can be removed for transponder mount
No other body modifications permitted
Suspension:
All suspension parts Need to remain stock as it comes out of the box
Shocks:
Factory equipped shocks only permitted.
Any shock oil and weight can be used.
Springs:
Traxxas factory equipped springs only. 1.6 blue
Steering:
the only servo saver allowed is Traxxas# 3744. Pinning the servo savor is not permitted.
Servo:
Traxxas# 2075R permitted
Electronics:
Traxxas# 3383 BL-2s ESC, 3384 BL-2s™ Brushless motor,
BATTERY:
only legal battery is SMC 5250-2SPWR 5200mAh-50C-7.4V 100% LCO Hardcase pack, MAX VOLTAGE CHARGED 8.4 VOLTS.
Transmitter/Receiver:
Traxxas TQ™ 2.4 GHz (2-channel) only
Transmission:
Factory Equipped Transmission permitted. Traxxas# 9495
Tires:
Stock Traxxas Slash modified tires only. Two fronts and two rears required on the car, but can be in any configuration.
TRA-10473X
TRA-10474X
GEARS:
23/86 gear combo only
Differential oils:
Any differential oil is permitted.
Chassis: 2 Mudboss
TRAXXAS 2wd Slash or Raptor chassis, no LCG chassis
Original MFG suspension parts only,Traxxas HD parts are Permitted, no other parts allowed (such as from RPM)
Original MFG chassis parts only,Traxxas HD Parts are permitted, no aftermarket hop-ups, no optional aluminum parts
Front bumper, right side bumper and front body post brace must be removed
Left side and rear bumpers can also be removed (if desired); rear RPM bumper is allowed
TRAXXAS front optional bumper (TRA2735) can be used if angled down
Alterations to the chassis or modification to drivetrain/suspension components is not allowed
Electronics (receiver, ESC & transponder) must be installed within chassis surface
Battery brace can be trimmed to allow different LiPo battery wire configurations MudBoss Rules Rev.0 02/4/24 2
Electronics:
Traxxas 12t brushed motor and XL5 ESC OR Traxxas BL-2S Brushless Power System
Optional 30mm motor fan allowed
Open gearing: any Traxxas spur gear, any pinion allowed
Servo must comply with Salvas Mudboss rules: TRX2075, optionally with Savox metal gears; SAVOX SC0252MG
Original TRAXXAS plastic servo saver / bell crank or solid servo horn allowed; servo saver can be immobilized
Any solid servo horn and servo steering rod can be used.
2-cell 7.4v LiPo battery with a maximum of 5200mah and 50c, with external plug (no bullets)
No overcharging batteries, MAXIMUM charge voltage of 8.42v
Adjustments:
Any original Traxxas Slash bearings can be replaced by any type/brand of bearings
No modifications can be made to the transmission’s case (i.e., to allow a bigger gear ratio)
The gear cover must be removed if asked
The only adjustments allowed to the car are those allowed by the original MFG components of the car
You are allowed to use any combination of black and gray Traxxas wheel hexes in any position
Transmission functionality rule: motor cannot spin while turning slowly one rear wheel a full turn
No Trassas Magnum 272R transmissions or parts allowed. Only legal transmission is Traxxas 272 with original gears
Traxxas Slash *STEEL* transmission gears only; plastic gears not allowed
Adding weight is not allowed except for the specific purpose of wheel balancing
Suspension:
Traxxas 2WD plastic shocks only (grey or black version), fronts in front, rears in rear
Original rear (TRAXXAS 5858) and front springs (TRAXXAS 5857) only
Front springs may be shortened by no more than five rounds on ONE end
The shock’s travel may be shortened with internal shims
Front shocks may only use the stock front shafts, rear shocks may only use the stock rear shafts
Original pistons from kit only (original 1,2 or 3 hole), no modifications can be made to them
No front bump stop suspension, a single original blue bump stop can optionally be used per rear shock
No shimming to reduce slop in suspension parts allowed
All suspension parts (such as A-Arms) must remain in original positions it was designed for (no swapping left to right)
Rear camber links must remain in original height position; upper hole on shock tower not allowed
Bodies:
Mudboss bodies only, Salvas or copy, but they must meet standard Salvas Mudboss body dimensions and appear to be a Salvas body from three feet away
Any minor modification to the body must be approved before being allowed.
The optional "NEXTGEN" inner panel is allowed and must be installed following the procedures posted on Facebook/YouTube https://tinyurl.com/3yjzashs The NEXTGEN inner panel rear spoiler must be mounted flat on the rear portion of the body and have a max of 1/2 inch above it
Bodies may be painted or wrapped, all bodies must be painted or wrapped to be legal for racing. Only the decking and rear spoiler may be left clear. Clear bodies will not be allowed
No additional drilling to lighten the body. Stainless steel screws, nylon screws or pop rivets may be used to fasten the body together.
Tires:
Any original TRAXXAS rubber tire / wheel / inserts (BFG / KUMHO / SPEC) any wheel combination of the SAME TIRE TYPE (ie.4 fronts, 4 rears, 3 front 1 rear…) *“S1” compound ALLOWED*
Traxxas front and rear offset rims may be used in any combination and position on the vehicle
Primary tread pattern must be visible across the width of each tire
GEARS:
23/86 gear combo only
Smokey Yunick Rule: if the rules don't say you can do it, you cannot do it.
ALL OTHER PARTS ARE TO REMAIN BOX STOCK IF ITS NOT COVERED IN THE RULES CONSIDER IT ILLEGAL.
